Name: China Manufacturers
Address: Room 2607, Meixin Plaza, No. 879 Xiahe Road, Siming District, Xiamen, XIA MEN, 351000, CN
Telephone: 13276021100
Rating: 4

On this page

Los defectos comunes y el tratamiento deintercambiadores de calorse muestran en la Tabla 2-2.

No.	Fault	Cause	Solution
1	Two kinds of media mingling together (internal leakage)	Corrosion perforation and cracking of heat exchange tubes Cracking of the expansion mouth (welding mouth) of the heat exchange tube and tube plate Sealing leakage of float head flange heat exchangers Sealing leakage of tight-ring type heat exchanger tube plates	Replace or block the leaky tube. Expand again (repair welding) or make blockage. Fasten bolts or replace sealing gaskets. Tighten inner ring compression bolts or replace packing (gaskets).
2	Flange seal leakage	Gaskets are under pressure, corrosion and deterioration. Bolts are weak, loose or corroded. Flanges lack of rigidity with sealing surface defects. Flanges are not parallel or misaligned. The gasket is of poor quality.	Tighten the bolt and replace the gasket. Upgrade Bolts material, fastening or replacing bolts. Replace flanges, or deal with their defects. Repair or replace the flange. Replace the gasket.
3	Poor heat transfer effect	Heat exchange tube scaling Poor water quality, oil pollution and microorganisms Clapboard short circuit	Remove scale by using chemical cleaning or jet cleaning method. Strengthen filtration and purification of media so as to strengthen water quality management. Replace the pipe box gasket or the partition.
4	Resistance exceeding allowable value	Filter failure Scale formation inside and outside the casing and the pipe	Clean or replace the filter. Clean the scale by jet or chemicals.
5	Severe vibration	Resonance caused by medium frequency Resonance caused by external pipe vibration	Change the flow rate or the natural frequency of the bundle. Reinforce the pipe to reduce vibration.

Table 2-2 Common failures and treatment of heat exchangers

¿Cuáles son las fallas comunes y el tratamiento de los intercambiadores de calor?

Leave a Comment

Related Supplier News

Cómo elegir tubos de acero sin costura para intercambiador de calor

¿Cuáles son las características del acero inoxidable para recipientes a presión?

¿Cuáles son las principales razones de la falla del intercambiador de calor de placas?

Causas de daños en los recipientes a presión